《Table 3 Orthogonal experimental design》

  提示：宽带有限、当前游客访问压缩模式

本系列图表出处文件名：随高清版一同展现

《选区激光熔化工艺参数对Ti6Al4V粉末成型性的影响（英文）》

1. 获取 高清版本忘记账户？点击这里登录

1. 下载图表忘记账户？点击这里登录

It can be seen from Table 3that the density can reach 96.17%when the laser power is 400 W，the lap rate is 1and the scanning speed is 750mm/min.The experimental parameters are the optimal process parameters.Using the optimized process parameters for SLM experiment，the mechanical properties test pieces are obtained[7].Under the same lap rate and scanning speed，the density of the molded parts increases with the laser power increasing.In the laser power range of 300-400 W，the density of the molded parts increases with the increase of the laser power.