《表2 椭圆轴承各参数计算结果对比[6]Tab.2 The comparison ofθand Fˉmcalculation results in elliptical bearing》
以文献[6]第五章表5-4中宽径比L D=1.0的圆柱轴承和表5-5中L D=0.5及椭圆比为0.5的椭圆轴承为例。圆柱轴承各参数计算结果见表1,偏位角θ的最大偏差不超过0.30%,承载量系数Fˉm的偏差最大不超过0.1%;椭圆轴承各参数计算结果见表2,偏位角θ的最大偏差不超过0.30%,承载量系数Fˉm的偏差最大不超过0.6%。本文的计算结果与文献[6]的结果吻合良好,从而验证了本文所述方法的计算程序的精度较高。
图表编号 | XD0017587500 严禁用于非法目的 |
---|---|
绘制时间 | 2018.02.26 |
作者 | 田奇勇、黄文俊、饶杰、朱晓农、王贤震 |
绘制单位 | 安徽安风风机有限公司 |
更多格式 | 高清、无水印(增值服务) |
查看“表2 椭圆轴承各参数计算结果对比[6]Tab.2 The comparison ofθand Fˉmcalculation results in elliptical bearing”的人还看了
- 表6 试件受弯承载力计算值与试验值对比Table 6 Comparison on the calculated values and tested values of the specimens’fexure capacity
- 表2 292 m高程处8号测点计算位移与实测位移对比Tab.2 Comparison of the calculated displacement and measured displacement at 8 points of 292 m