《Table 1Different sets of power,speed,and layer thickness.》
In order to better understand the melt track characteristics,we will modify the F value to only show the deposited melt track instead of the whole powder bed.To extract the melt track,the unmelted parts/cells are excluded by setting their F value at 0.Whether or not a cell is melted depends on the temperature history:If the temperature value never exceeds the melting point,then a factor of 0 is assigned to the cell,while melted parts are assigned a factor of 1.The final 3D F matrix value is obtained by multiplying the F matrix and the factor in each cell.In this way,the isosurface of the melt track is constructed,as shown in Fig.3(b).
图表编号 | XD001945800 严禁用于非法目的 |
---|---|
绘制时间 | 2019.08.01 |
作者 | 钱亚、闫文韬、林峰 |
绘制单位 | Department of Mechanical Engineering, Tsinghua University、Biomanufacturing and Rapid Forming Technology Key Laboratory of Beijing, Tsinghua University、Department of Mechanical Engineering, National University of Singapore、Department of Mechanical Engineer |
更多格式 | 高清、无水印(增值服务) |
查看“Table 1Different sets of power,speed,and layer thickness.”的人还看了
- 表2 整个青藏高原模型模拟的活动层厚度和年平均地温Table 2The active layer thickness and mean annual ground temperature (mean±standard deviation)
- 表3 2∶1、1∶2和2∶2型强电解质溶液的表面层厚度Tab.3 The thicknesses (nm) of the surface layer of 2∶1, 1∶2 and 2∶2 strong electrolytes